在應用中應當進行定期維護和檢驗檢修，今日，山東省ABB高壓變頻器維修故障生產廠家來給大伙兒共享一下下工作經驗!
In the application, regular maintenance and inspection should be carried out. Today, Shandong ABB High Voltage Inverter Maintenance Fault Manufacturer to share the next work experience for everyone!
1、變頻器定期檢查項目
1. Frequency Converter Regular Inspection Items
1)開關電源工作電壓確定合乎軟啟動器需要工作電壓；布線接線端子和射頻連接器，是不是松脫(電源插頭與接線端子中是不是有斷股)；
1) The working voltage of switching power supply conforms to the requirement of soft starter, wiring terminal and radio frequency connector are loosened (whether there is a broken strand in the power plug and terminal);
2)變頻器內部是否有灰塵，輸出電流，輸出頻率(量出結果其差距不可太大)；
2) Whether there is dust inside the converter, output current and output frequency (the difference between measured results can not be too large);
3)檢查周圍的溫度是否在-5℃ ~ 40℃之間，安裝環境是否通風良好；
3) Check whether the ambient temperature is between - 5 40 and whether the installation environment is well ventilated.
4)濕度：維持在百分之90以下(不可有結水滴的現象)；
4) Humidity: keep below 百分之90 (no water droplets);
5)運轉中有無異常聲音或異常振動現象(變頻器不可置于振動大的地方)；
5) Whether there is abnormal sound or abnormal vibration in operation (the frequency converter should not be placed in the place where the vibration is large);
6)通氣孔敬請定期做清掃工作。
6) Ventilation holes should be cleaned regularly.
2、變頻器維修檢測注意事項
2. Notices for Frequency Converter Maintenance and Inspection
1)維護檢查時，務必先切斷輸入變頻器(R.S.T)的電源；
1) When maintaining and checking, it is necessary to cut off the power supply of the input converter (R.S.T).
2)確定變頻器電源切斷，顯示消失后，等到內部高壓指示燈熄滅后，才實施維護、檢查；
2) Make sure that the power supply of the converter is cut off and the display disappears. After the internal high-voltage indicator is extinguished, the maintenance and inspection will be carried out.
3)在檢查過程中，不可以將內部電源及線材，排線拔起及誤配，否則會造成變頻器不工作或損壞；
3) In the process of inspection, internal power supply and wire must not be pulled up and mismatched, otherwise the converter will not work or damage;
4)安裝時螺絲等配件不可置留在變頻器內部，以免電路板造成短路現象；
4) When installing, screw and other accessories should not be left inside the converter, so as to avoid short circuit caused by circuit board.
5)安裝后保持變頻器的干凈，避免塵埃，油霧，濕氣侵入。
5) Keep the frequency converter clean after installation, avoid dust, oil mist and moisture intrusion.
http://www.a136771832.cn/